Delphi FE0110 Electric Fuel Pump

Delphi FE0110 Electric Fuel Pump. When it comes to the aftermarket, nobody does it better than Delphi Technologies.

While many OEM suppliers put the aftermarket last, we routinely put it first, understanding customer lifetime value is often best delivered through the parts & service experience. Our lineup includes parts, equipment, software and training - all geared to put you a step ahead in servicing and maintaining sophisticated vehicle systems. We've got you covered with fuel systems, air conditioning, engine management, steering & suspension, advanced diagnostic equipment, e-catalogs and more. NON-CARB COMPLIANCE NOTICE: OUR CATALYTIC CONVERTERS ONLY MEET EPA EMISSIONS STANDARDS.

AS SUCH, BUYERS FROM, BUT NOT LIMITED TO, THE STATES OF CALIFORNIA, CONNECTICUT, DELAWARE, MAINE, MARYLAND, MASSACHUSETTS, NEW JERSEY, NEW MEXICO, NEW YORK, OREGON, PENNSYLVANIA, RHODE ISLAND, VERMONT, WASHINGTON STATE, and WASHINGTON D. ARE REQUIRED TO VERIFY THAT THEIR VEHICLES ARE DESIGNED TO MEET FEDERAL NOT C. IF YOU ARE UNSURE, PLEASE REACH OUT TO US OR TALK TO YOUR LOCAL DEALER.

However, catalytic converter failure is often the result of pre-existing engine problems (fuel trim issues, burning oil, or failed o2 sensors) PRIOR to replacing a cat, ensure all systems are functioning correctly or you may experience repeated failure. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts & Accessories\Air & Fuel Delivery\Fuel Pumps & Sending Units". The seller is "parts_evolved" and is located in this country: CA. This item can be shipped to United States, Canada.

• Manufacturer Warranty: 1 Year
• Brand: Delphi
• Manufacturer Part Number: FE0110
• Average Current Draw: 5 68
• Average Flow Rating: 22 GPH
• Connector Gender: Male
• Connector Shape: Square
• Fuel Pump Inlet Type: Strainer
• Fuel Sending Unit Included: NO
• Fuel Type: Gas
• Gasket Or Seal Included: YES
• Gasket Or Seal Material: Nitrile Rubber
• In Tank or External: In Tank
• Inlet Outside Diameter: 19.0 MM
• Inlet Type: Strainer
• Item Grade: Standard Replacement
• Length: 128.0 MM
• Maximum Pressure: 70.0 PS
• Mounting Bracket Included: NO
• Mounting Hardware Included: YES
• Negative Ground: NO
• Outlet Outside Diameter: 0.313 IN
• Outlet Quantity: 1
• Outlet Type: Straight
• Position(s): In-Tank
• Pump Design: Turbine
• Regulator Included: NO
• Seal And Lock Ring Included: NO
• Strainer Included: NO
• System Pressure: 44 psi
• Terminal Gender: Male
• Terminal Quantity: 2
• Terminal Type: Pin
• Voltage: 12 2H
• Wire Quantity: 0
• Wiring Harness Included: NO
• Country of Origin: Mexico
• UPC: 689604033784

---